A gas hob that clicks and clicks without lighting is annoying, and often fixable in ten minutes with a cloth. A gas hob that does something else — smells of gas, burns yellow, lights and then goes out — is a different matter entirely, and this guide is careful about the distinction.
What you can safely do
Exactly one category of thing: clean, dry and correctly reseat the removable burner parts. That is not a limitation invented for caution — it happens to fix the majority of ignition complaints, because the majority are caused by spillage.
The burner is dirty or wet
By far the most common cause. Something has boiled over, run into the burner, and either blocked the gas ports or wetted the igniter.
With the hob cold and off:
- Lift off the pan support and the burner cap — the flat disc on top.
- Lift off the burner crown underneath — the ring with slots or holes around its edge.
- Wash both in hot soapy water. Clear every slot; a cocktail stick or a soft brush works, a pin is fine for a stubborn one. Do not enlarge the holes with anything metal and forceful.
- Dry them completely. This matters more than the washing. A damp burner will not light, and people frequently refit them still wet and conclude the repair failed.
- Wipe around the igniter electrode — the small ceramic-tipped probe beside the burner — with a dry cloth. Food residue or moisture on it stops the spark reaching where it needs to.
- Refit everything squarely. Most burner crowns have a locating notch or pin and will only sit correctly one way. A crown sitting a few millimetres out will not light, will light unevenly, or will burn with a yellow flame.
That last point is the second most common cause after dirt: a burner reassembled slightly wrong after cleaning.
It clicks but does not light
The spark is being generated, so the ignition circuit is working. Look at:
- Is gas reaching the burner? If other burners light, yes. If none of them light, check the gas supply — the meter, the isolation valve behind the cooker, and whether you have credit on a prepayment meter.
- Is the burner clean and dry? As above.
- Is the crown seated correctly? As above.
It does not click at all
No spark. On a mains-powered hob, check the appliance has power: a built-in hob may be on its own fused spur, and a blown fuse or tripped breaker takes the ignition out while the gas still works. Some freestanding cookers use a battery for the igniter — check the manual.
Beyond that, a failed ignition module or a failed switch is a repair, and on a gas appliance that means a Gas Safe registered engineer.
Every burner clicks when you light one
Normal on many hobs — they use a single module that sparks all electrodes at once. Continuous clicking that does not stop after the burner lights is not normal, and usually means moisture around a control knob or an electrode. Dry everything thoroughly and give it a day.
It lights but goes out when you release the knob
This is the flame supervision device doing its job, and it is a safety feature, not an inconvenience.
Gas hobs have a thermocouple: a probe in the flame that generates a small voltage when hot, holding the gas valve open. If the flame goes out, the probe cools, the voltage falls and the gas shuts off. That is what prevents unburnt gas filling your kitchen.
You have to hold the knob in for a few seconds when lighting to give it time to warm up. If you are already doing that and it still cuts out, the thermocouple may be dirty, misaligned or failing.
Do not attempt to adjust or bypass it. It is the component that stops your kitchen filling with gas. This is Gas Safe work.
Signs that mean stop and call someone today
- Any smell of gas. Windows open, gas off at the meter, no electrical switches, leave, call 0800 111 999.
- Yellow or orange flames instead of blue. A blue flame is correct combustion. Yellow or orange suggests incomplete combustion, which produces carbon monoxide. Stop using it.
- Black or sooty marks on pans or around the burner.
- Symptoms of carbon monoxide exposure — headaches, nausea, dizziness or drowsiness that improve when you leave the house. Get out and get medical advice.
- The hob lights with a bang, or gas escapes for a noticeable moment before igniting.
A working audible carbon monoxide alarm in any room with a gas appliance is inexpensive and worth having. It is not a substitute for servicing.
Electric ignition on an electric or induction hob
Not applicable — those have no ignition. If an electric hob element or induction zone is not working, see hob repair.
Cover
A failed ignition module, switch or thermocouple is a mechanical breakdown and is normally within scope of appliance cover. Two things to check before you rely on it. First, some policies exclude gas appliances entirely, or cover the electric parts of a dual-fuel cooker but not the gas ones. Second, any repair must be carried out by a Gas Safe registered engineer, so check the provider uses them — a reputable one will.
A burner that will not light because it needs cleaning is maintenance, and the visit will be chargeable. See what each provider covers on our oven and cooker cover comparison.